One of the two parts of my 3D computer sculpture has been printed. It is still a bit sticky because the resin hasn't cured yet. It stands 10" X 10" X 6". The two parts will intertwine.
Over all I am surprised how much it looks like the 3D computer model. It is in no way a finished sculpture yet. There are some issues to work on, for one, it is suppose to be hollow but I made the drain holes on the bottom to small so the liquid resin stared to set up before it could all drain out.
As you can see in this detailed photo there are air bubbles in the front legs. To solve this we are going to reprint them as solid clear resin. This will remove the blown glass quality of the sculpture, but the dead line for the SculptCAD Rapid Artists project is to close to reengineer it.
No comments:
Post a Comment